Flap Disc Grinding Ratio Testing Machine

• Customization: Available
• Voltage: 380V
• Origin: China
• Model NO.: Flap disc grinding ratio testing machine
• Package Size: 120.00cm * 120.00cm * 180.00cm
• Package Gross Weight: 1000.000kg

Product Description

Flap disc grinding ratio testing machine-New
KWT-GR-New this equipment is special equipment for testing the grinding ratio of louver blades developed by our company (especially used in laboratories), which can test the grinding degree of the flap disc. After years of market verification, our equipment is required to be more high-end.
The louver grinding ratio test equipment can achieve 90% simulation, better simulate real-life grinding, and can uniformly control the grinding angle, strength and speed. And you can set basic data such as time, speed, and strength.
The equipment is exquisite and easy to use, and it is equipped with a protective cover and a dust and iron chip recovery device, which can be placed indoors for safe use.

Precautions:
1. When handling this product, please be careful not to drop, bump or shake it strongly. Tilt ≤ 45 degrees.
2. The machine should be installed on a fixed foundation indoors, and pay attention to easy operation and good ventilation. There should be no conductive dust and gas that can corrode metal or damage insulation nearby. The heat dissipation holes on the body should be kept unblocked, and please clean up the iron chips and dust in time after use.
3. This machine uses single-phase AC 220v power supply, the voltage range is 220v±10%, the maximum current is 20A, and the frequency is 50Hz. The load capacity of the power supply should be considered when wiring.
4. A knife switch or an air switch or a leakage protector should be installed between the machine and the power supply so that the machine can be completely isolated from the power supply. Ground wires should be installed at the feet of the body and reliably connected to the ground.
5. Without the permission of the factory, users should not disassemble the controller or motor by themselves, so as not to cause electric shock or damage to the equipment.
6. Please be sure to cover the protective cover before use.
A detailed explanation of the machine:
1. Equipment size: 1400mm*1500mm*1600mm, please place the equipment stably, due to the equipment grinding test, there may be sparks, please keep away from combustibles.

Basic specification
Flap disc Type	T27/T29 ;100mm-180mm	Voltage	220V
Power	3.5KW	Weight	300KG
Ammeter	YQAOB	Hour meter	OMRON
Rail slider	HIWIN	Air pressure	0.24-0.25MPa
Machine size	800mm*600mm*1400mm	Angle Grinder	STANLEY

Simple Performance features :
.  Save labor cost
.  Improve production efficiency
.  Good quality products
.  Stable production
.  Humanization design